Floating Wind Turbines: The Wave of the Future
Four hundred huge offshore floating wind turbines are providing onshore customers with enough electricity to power several hundred thousand homes, and nobody standing onshore can see them. The trick? The floating wind turbines are floating on platforms a hundred miles out to sea, where the winds are strong and steady.
Today’s offshore floating wind turbines usually stand on towers driven deep into the ocean floor. But that arrangement works only in water depths of about 15 meters or less. Proposed installations are therefore typically close enough to the shore to arouse strong public opposition.
Their design calls for a tension leg platform (TLP), a system in which long steel cables, or “tethers,” connect the corners of the platform to a concrete block or another mooring system on the ocean floor. The platform and turbine are thus supported not by an expensive tower but by buoyancy.
According to their analyses, the floater-mounted turbines could work in water depths ranging from 30 to 200 meters. In the Northeast, for example, they could be 50 to 150 kilometers from shore. And the turbine atop each platform could be big — an economic advantage in the wind-farm business.
Offshore Floating Wind Turbines
Ocean assembly of the floating turbines would be prohibitively expensive because of their size: the wind tower is fully 90 meters tall, and the rotors are about 140 meters in diameter. So the researchers designed them to be assembled onshore—probably at a shipyard—and towed out to sea by a tugboat. To keep each platform stable, cylinders inside it are ballasted with concrete and water. Once on site, the platform is hooked up to previously installed tethers. Water is pumped out of the cylinders until the entire assembly lifts up in the water, pulling the tethers taut.
The tethers allow the floating platforms to move from side to side but not up and down. According to computer simulations, in hurricane conditions, the floating platforms—each about 30 meters in diameter—would shift by one to two meters, and the bottom of the turbine blades would remain well above the peak of even the highest wave. The researchers are hoping to reduce the sideways motion further by installing specially designed dampers similar to those used to steady the sway of skyscrapers during high winds and earthquakes.
- Drum Brakes a Type of Mechanical Brake | Construction and Working of a Drum Brake System
- Lighting System of a Car | Car Lightings
- Pneumatic Braking System In Automobile | Air Braking System | Construction And Working Of Pneumatic Braking System
- Torsion Bar Suspension System In Automobile | Construction And Working Of Torsion Bar Suspension
- Suspension System of an Automobile | Needs of Suspension System in an Automobile | Broad Classification of suspension system of a vehicle
- Construction and Working of Disk Brakes in an Automobile | Disk Brakes a Type of Mechanical Braking System