Mechanical Engineering Career Information
- 1 Mechanical Engineering Career Information
- 1.0.1 What is Heat rate of a Power plant?
- 1.0.2 The highest value of Thermal conductivity is expected for
- 1.0.3 What is a Hydrostatic system?
- 1.0.4 If you heat a piece of steel with a hole in the center will the diameter of the steel get bigger or smaller?
- 1.0.5 What is the difference between Blower and Fan?
- 1.0.6 How to find a Ductile-Brittle Transition Temperature in metals?
- 1.0.7 What is Hydrodynamic Cavitation?
What is Heat rate of a Power plant?
Heat rate is a measure of the turbine efficiency. It is determined from the total energy input supplied to the Turbine divided by the electrical energy output.
The highest value of Thermal conductivity is expected for
a.) Solid ice b.) Melting ice c.) Water d.) Boiling water.
Give the Thermal conductivity value.
Solid Ice – 3.48 W/mK
Melting Ice thermal conductivity value is low because temperature is less.
Water’s Thermal conductivity value is 2.18 W/mK.
What is a Hydrostatic system?
Hydrostatics is the study of ﬂuid bodies that are
- At rest
- Moving suﬃciently slowly so there is no relative motion between adjacent parts of the body
For hydrostatic situations
- There are no shear stresses
- There are only pressure forces that act perpendicular to any surface.
It’s a closed loop hydraulic systems. It comprises of motor and pump. Here pump supplies energy to motor and motor gives return energy to pump supply.
If you heat a piece of steel with a hole in the center will the diameter of the steel get bigger or smaller?
It gets bigger.
(Example: Always the bearings are heated first for new installation in a shaft.)
What is the difference between Blower and Fan?
Fan is an air pushing device. Either Axial or Centrifugal type systems are used to move the air in low pressure. It is rotated by a motor separately.
When the fan is a housing of blades and motor, then it called as Blower. It directs the air in a single path with high pressure.
How to find a Ductile-Brittle Transition Temperature in metals?
The point at which the fracture energy passes below a pre-determined point for a standard Impact tests. DBTT is important since, once a material is cooled below the DBTT, it has a much greater tendency to shatter on impact instead of bending or deforming.
What is Hydrodynamic Cavitation?
Hydrodynamic cavitation describes the process of vaporization in a constrained channel at a specific velocity.
Bubble generation and Bubble implosion which occurs in a flowing liquid as a result of a decrease and subsequent increase in pressure.